Make sure you purchase the right ink cartridges for your specific printer and printer region or have your old ones refilled. Cartridges are not compatible between different brands, and often not within the same brand. HP often designs its inkjet hardware to use country-specific consumables. When you unbox a new HP inkjet printer and set it up, you install a set of ink tanks that ship with the printer. As you turn on the device and get ready to use it, an initialization sequence localizes it to the country associated with the ink cartridges you installed.
HP recommends that you use original HP ink cartridges. XL (Extra Large) cartridges cost more but do provide better value in the long run. They will be able to print at least double the pages of a regular cartridge. Our advice is that if you print often, go with XL. However, ink can dry up. So if you are not a frequent printer, go with the regular cartridges.
You can check the estimated ink levels from the printer control panel or from the printer software. Ink level warnings and indicators provide estimates for planning purposes only. When you receive a low-ink warning message, consider having a replacement cartridge available to avoid possible printing delays. You do not have to replace the cartridges until prompted to do so.
For your US HP OfficeJet 6958 All-in-One printer you need 1 HP 902 Black OR the XL-version HP 902XL Black AND 3 color cartridges: HP 902 Cyan/Magenta/Yellow OR the XL-version HP 902XL Cyan/Magenta/Yellow.
There are also Combo Packs (4 cartridges in one pack) available, like the HP 902XL/902 Black/Tri-color Ink Cartridges, Pack Of 4 Black/Cyan/Magenta/Yellow.
For your European or UK HP OfficeJet 6958 All-in-One printer you need 1 HP 903 Black OR the XL-version HP 903XL Black cartridge AND 3 color cartridges: HP 903 Cyan + HP 903 Magenta + HP 903 Yellow cartridges. OR the XL-version of the color cartridges: HP 903XL Cyan + HP 903XL Magenta + HP 903XL Yellow.
Remove the old cartridge
2. Open the cartridge access door.
Locate the two slots on the sides of the printer. Place your fingers in the slots, and then lift to open the ink cartridge access door. Wait until the carriage is idle and silent before you proceed.
Insert the new cartridge
4. Remove the new ink cartridge from its packaging by pulling the orange pull-tab straight back to remove the plastic wrap from the ink cartridge. Make sure you remove the orange pull-tab completely. When you remove the plastic wrap, the paper label on the top of the cartridge tears slightly, which is necessary to vent the cartridge. Do not touch the copper-colored electrical contacts and ink port.
7. Hold the ink cartridge so that the ink cartridge contacts are facing down and toward the printer. Match the colored dot on the ink cartridge with the dot of the same color on the carriage. Slide the new ink cartridge into its slot, and then gently press the ink cartridge down until it clicks into place and is seated firmly in the slot. Make sure that the color-coded letter on the cartridge matches that on the slot.
8. Repeat step 3 to 7 for each ink cartridge you are replacing.
Align the printhead only if necessary.
The printer automatically aligns the printhead during the initial setup. The printhead does not have to be realigned when cartridges are replaced. However, you might want to use this feature for print quality issues in printouts where straight lines look wavy or jagged. You can align the printhead from the printer control panel and from the HP printer software.